Results 1 to 4 of 4
12-16-2016, 06:13 AM #1
How do i get mpc style pitched drum pads with kong ??
Mpc style pitched drum rolls******
Sent from my iPhone using Tapatalk
Last edited by therealdstef; 12-16-2016 at 06:15 AM.
12-16-2016, 03:14 PM #2
You can sample them, load samples in or just write them in the sequencer yourself.Daw's are just a tool.
12-16-2016, 05:26 PM #3
12-17-2016, 11:42 AM #4
that would require some nifty reason creative routing with a bunch of thor's. Fun project to do, but that'll require quite a bit of knowledge and creative source using.
You'd have to start of using a combinator; play the combinator in stead of the kong.
Then have a thor instance per pad, so 16 of them. Assign every Thor to only one midi note, so starting from C1 then going up 16 times. So thor 1 triggers on C1, thor 2 plays on C#1 and so on.
Then have all the thors set up the same (copy and paste patches); set the gate trigger to trigger the thor sequencer "RUN" mode, then use the sequencers gate as a trigger for the pads (hard wire them) so when thors sequencer starts, it'll trigger the drum pads in a quantized manner.
Then have like the thors envelope or lfo source as a cv pitch modulation source to each kong pad's pitch.
So unless you like routing, doing creattive reason stuff and want to have a similar patch under your finger tips in an instance in the future, just draw the drum roll in the sequencer and add draw in a pitch modulation.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)