Results 1 to 4 of 4
-
12-16-2016, 07:13 AM #1
How do i get mpc style pitched drum pads with kong ??
Mpc style pitched drum rolls******
Sent from my iPhone using TapatalkLast edited by therealdstef; 12-16-2016 at 07:15 AM.
-
12-16-2016, 04:14 PM #2
You can sample them, load samples in or just write them in the sequencer yourself.
Daw's are just a tool. Learn The VSSL In Reason - Learn How to Mix
-
12-16-2016, 06:26 PM #3
-
12-17-2016, 12:42 PM #4
that would require some nifty reason creative routing with a bunch of thor's. Fun project to do, but that'll require quite a bit of knowledge and creative source using.
You'd have to start of using a combinator; play the combinator in stead of the kong.
Then have a thor instance per pad, so 16 of them. Assign every Thor to only one midi note, so starting from C1 then going up 16 times. So thor 1 triggers on C1, thor 2 plays on C#1 and so on.
Then have all the thors set up the same (copy and paste patches); set the gate trigger to trigger the thor sequencer "RUN" mode, then use the sequencers gate as a trigger for the pads (hard wire them) so when thors sequencer starts, it'll trigger the drum pads in a quantized manner.
Then have like the thors envelope or lfo source as a cv pitch modulation source to each kong pad's pitch.
So unless you like routing, doing creattive reason stuff and want to have a similar patch under your finger tips in an instance in the future, just draw the drum roll in the sequencer and add draw in a pitch modulation.SoundCloud/ Osmose-music - Facebook/ OsmoseSounds -
osmose-music.com - osmose-music.bandcamp.com
"When you quiet to mind, you're not quit the mind" - Arcturus Ra -
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks